漳州摩托车科目四英文题库

1. The article that cannot be used to stop bleeding by dressing is _________.

A. Bondage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

2. When a motorcycle is making a turn in a high speed, the driver should avoid using the brake or use the brake less to prevent sideslip.

A. Right

B. Wrong

Answer: A

3. What is the meaning of this sign?

A. Road narrows on both sides

B. Road narrows on the right side

C. Road narrows on the left side

D. Bridge narrows

Answer: A

4. When a tire blowout on the road, the driver should control the direction of the vehicle and use emergency braking to bring the motorcycle swiftly to a stop.

A. Right

B. Wrong

Answer: B

5. A correct measure to avoid tire burst of motor vehicles is to lower the tire pressure.

A. Right

B. Wrong

Answer: B

6. When passing an intersection, vehicle motor drivers are not allowed to overtake.

A. Right

B. Wrong

Answer: A

7. How to do in this situation?

A. Stop and yield to the pedestrians

B. Bypass from the front of the pedestrians

C. Honk to remind the pedestrians

D. Bypass from the rear of the pedestrians

Answer: A

8. When a motor vehicle reaches a muddy or burst-and-muddy section of the road, the driver should stop, observe and select a level and solid section or a section with vehicle tracks.

A. Right

B. Wrong

Answer: A

9. Matches, sulfur and red phosphorus are _________.

A. Explosives

B. Inflammable solid materials

C. Self-igniting articles

D. Oxidizing materials

Answer: B

10. What is the meaning of this sign?

A. Electric bicycles may go

B. Parking space for non-motorized vehicles

C. Parking area for non-motorized vehicles

D. Non-motorized vehicles may go

Answer: D

11. What is the meaning of this sign?

A. Slippery section

B. Sharp curve

C. Inverse curve

D. Continuous curves

Answer: C

12. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

13. When a rear tire of a motorcycle blows out, the driver should ________.

A. Swiftly turn the steering handlebar to adjust

B. Firmly hold the steering handlebar with both hands

C. Swiftly turn the steering handlebar to the opposite direction

D. Swiftly take braking measures

Answer: B

14. Which measures is correct when a motor vehicle intends to overtake

A. After overtaking, turn on the right turning light and drive back to the original lane after the necessary safe distance has been pulled away by overtaking.

B. Overtaking from the left side of the previous car

C. After overtaking, turn on the right turn light and drive back to the original Lane immediately.

D. Overtake on the right side

Answer: AB

15. What should be done by the driver who intends to overtake but finds that the vehicle in front is also overtaking?

A. Following the vehicle in front closely and finding a chance to overtake it

B. Accelerating to overtake forcefully

C. Continuously sounding the horn to urge the vehicle in front to yield

D. Refraining from overtaking and letting the vehicle in front overtake first

Answer: D

16. When encountering a school bus which stops at the right roadside and students are embarking or disembarking, what should motor vehicle drivers do?

A. If there is only one motor vehicle lane in each direction, motor vehicle drivers behind the bus should stop and wait.

B. If there are two motor vehicle lanes in each direction, motor vehicle drivers in the left lane behind the bus may overtake the bus at a lower speed

C. If there are three motor vehicle lanes in each direction, motor vehicle drivers in the middle lane behind the bus should stop and wait

D. If there are three motor vehicle lanes in each direction, motor vehicle drivers in the left lane behind the bus may pass at a lower speed

Answer: ACD

17. How to do in this intersection?

A. Wait in the cross-hatched marking area

B. stop and wait outside the intersection

C. Follow the vehicle in front and pass

D. Wait inside the intersection

Answer: B

18. What is the meaning of this sign?

A. No passing for small vehicle

B. Passing for small vehicle only

C. Passing for motorized vehicle

D. No passing for small vehicle

Answer: C

19. When a motorcycle goes downhill, it may fully use the neutral gear and slide.

A. Right

B. Wrong

Answer: B

20. What is the meaning of this sign?

A. Bump road

B. High outburst road

C. Low-lying road

D. Hump bridge

Answer: B

21. When the vehicles cross each other at night, what should the driver do if the vehicle coming in the opposite direction always use the high beam light.

A. Continuous change lights and honk to remind the vehicle coming in the opposite direction

B. Turn on the high beam light

C. Reduce speed or driving on the right side.

D. Move his sight to the right side to evade the light

Answer: CD

22. At a road that has more than two vehicle lanes in the same direction, the motorcycles should use the very left one.

A. Right

B. Wrong

Answer: B

23. When driving a motor vehicle following anther vehicle, What should the driver pay attention to?

A. When following a taxi, it is necessary to prevent it from pulling over at any time to get on and off passengers.

B. For large trucks loaded with goods, we should increase the distance between cars and avoid long time follow ups to prevent the risk of cargo spilling and blind areas.

C. When the current side of the vehicle has an internship sign, it should increase the distance with the vehicle to prevent the front vehicle emergency braking.

D. Follow a vehicle in foggy weather, pay attention to the emergency braking of the front vehicle

Answer: ABCD

24. After setting off from a roadside, motor vehicle drivers should watch both sides of the road, turn left and drive into the normal lane slowly.

A. Right

B. Wrong

Answer: A

25. When approaching a sharp curve, motor vehicle drivers should reduce speed only after entering the curve.

A. Right

B. Wrong

Answer: B