烟台最新摩托车科目四试题库英文题

1. When a vehicle stops temporarily at the roadside at night, the wrong measure is to ______.

A. Turn on the warning flash light

B. Turn on the contour light

C. Turn on the high beam light

D. Turn off all lights

Answer: CD

2. When rescuing a wounded person who has been poisoned by toxic gas, the first measure is to send him to a place where air is fresh so that he will not continue to be poisoned.

A. Right

B. Wrong

Answer: A

3. How to ensure safe driving at night?

A. Drive at speed limit

B. Cut speed and drive carefully

C. Maintain the current speed

D. Drive above the speed limit

Answer: B

4. Motor vehicle drivers don’t need to use any lamp at night when passing through a road section where the street light condition is good.

A. Right

B. Wrong

Answer: B

5. At a road that has more than two vehicle lanes in the same direction, the motorcycles should use the very left one.

A. Right

B. Wrong

Answer: B

6. When driving on a foggy day, the driver should turn on the fog lamp.

A. Right

B. Wrong

Answer: A

7. There is a risk of overtaking when driving a motor vehicle approaches the top of the slope on a mountainous road, because _____.

A. When approaching the top of the slope, the line of sight is blocked and it is impossible to observe the traffic situation.

B. When approaching the top of the slope, the line of sight is blocked. It is impossible to observe whether there are obstacles behind the top of the slope.

C. The speed is slower when approaching the top of the slope.

D. When approaching the top of the slope, the line of sight is blocked and the road direction behind the top of the slope can not be observed.

Answer: ABD

8. When approaching a sharp curve, motor vehicle drivers should reduce speed only after entering the curve.

A. Right

B. Wrong

Answer: B

9. How should lamps be used when a motor vehicle meets an oncoming bicycle on a narrow road or a narrow bridge at night?

A. Continuously change between low-beam and high-beam

B. Use clearance lamp

C. Use high-beam

D. Use low-beam

Answer: D

10. When a motor vehicle encounters a burning phenomenon, it should leave the vehicle quickly so as not to cause injury or asphyxia to the respiratory tract.

A. Right

B. Wrong

Answer: A

11. What is the meaning of this sign?

A. Reduce speed and go slowly

B. Watch for danger

C. Jammed section

D. Accident-prone section

Answer: B

12. What is the meaning of this sign?

A. No going straight and no changing to left lane

B. No going straight and no left turn

C. Allowed to go straight and turn left

D. No going straight and no right turn

Answer: B

13. When the engine suddenly stalls on the road, what should the driver do?

A. Stop the vehicle and overhaul it immediately

B. Immediately turn on the hazard lamps

C. Move the vehicle to a place where it will not obstruct the traffic flow

D. Set up a breakdown warning sign

Answer: BCD

14. What is the meaning of this sign?

A. Electric bicycles may go

B. Parking space for non-motorized vehicles

C. Parking area for non-motorized vehicles

D. Non-motorized vehicles may go

Answer: D

15. When a motor vehicle stops temporarily in a rainy day,which lamp should be turned on?

A. Front and rear fog lamps

B. Hazard lamps

C. Headlamps

D. Reverse lamps

Answer: B

16. The wrong measure to ride a motorcycle in summer is to __________.

A. Drive at a high speed for a long time

B. Control the speed by the accelerator

C. Avoid using the brake

D. Avoid loading people or cargoes

Answer: A

17. When driving on a muddy road, what should the driver do?

A. Try to avoid using the foot brake

B. Stop and observe the road ahead

C. Avoid shifting halfway as much as possible

D. Put in low gear ahead of time

Answer: ABCD

18. It is extremely unsafe to take a motorcycle by the side; if the motorcycle sideslips, the passenger may be thrown out and led to death due to an unstable center of gravity.

A. Right

B. Wrong

Answer: A

19. In which of the following ways can motor vehicles avoid a tire burst?

A. Lowering tire pressure

B. Checking tires regularly

C. Removing foreign matters from the tire tread grooves timely

D. Replacing the tires that have cracks or deep cuts

Answer: BCD

20. What is the meaning of this sign?

A. No long time honking

B. Honk discontinuously

C. Reduce speed and honk

D. No honking

Answer: D

21. What is the meaning of this sign?

A. More vehicles section

B. Passing slowly

C. Jammed section

D. Construction section

Answer: B

22. How should lamps be used when motor vehicle drivers pass through a two-way tunnel?

A. Turn on the hazard lamps

B. Turn on the high-beam

C. Turn on the fog lamp

D. Turn on the low-beam

Answer: D

23. When overtaking a motor vehicles on uphill sections of a mountain road, the driver should _____.

A. Honk in advance

B. Forward cars are allowed to overtake before overtaking.

C. Turn on the left-turn signal in advance

D. Speed up direct and overtake

Answer: ABC

24. What is the meaning of this sign?

A. Speed up when the driver can not see the pedestrians

B. Speed up

C. There is a crosswalk ahead.

D. Keep driving at the same speed when you can not see the pedestrians

Answer: C

25. When a motorcycle reaches a muddy or burst-and-muddy section, the driver should stop, observe and select the level and solid section or the section with vehicle tracks.

A. Right

B. Wrong

Answer: A