鹤壁摩托车英语题库PDF

1. The sign above the tunnel indicates a height limit of 3.5 meters on the road ahead.

A. Right

B. Wrong

Answer: A

2. In this driving condition, drivers should turn on the high-beam when setting off.

A. Right

B. Wrong

Answer: B

3. When an erosive material catches fire, it should not be put out with water cannon.

A. Right

B. Wrong

Answer: A

4. Which lamp should be used when motor vehicles pass through an intersection at night where there is no traffic light signal?

A. High-beam

B. Low-beam

C. Hazard lamps

D. High-beam and low-beam should be used alternatively

Answer: D

5. Under such circumstances, motor vehicle drivers should reduce speed by the right side swiftly and yield.

A. Right

B. Wrong

Answer: A

6. The sign on the right indicates a section for ascertaining the distance between the vehicles 200 meters ahead.

A. Right

B. Wrong

Answer: A

7. When driving on a muddy road, the driver should hold the steering wheel firmly and speed up to pass through.

A. Right

B. Wrong

Answer: B

8. The diamond-shaped broken line warns that drivers should drive at a lower speed on the road sections ahead.

A. Right

B. Wrong

Answer: A

9. Which of the following materials should not be used to stop bleeding?

A. Bandage

B. Sling

C. Tourniquet

D. Hemp rope

Answer: D

10. The right-front sign indicates a time-regulated pedestrian area.

A. Right

B. Wrong

Answer: A

11. The sign in front indicates the name and number of the highway.

A. Right

B. Wrong

Answer: A

12. When a motor vehicle encounters thick fog on an expressway and the visibility is poor, the driver should immediately brake and stop.

A. Right

B. Wrong

Answer: B

13. The sign on the right warns that the road will narrow over the next 5 kilometers.

A. Right

B. Wrong

Answer: A

14. The driver may not change lanes when the motor vehicle turns right at this intersection.

A. Right

B. Wrong

Answer: B

15. When approaching another vehicle at night, why should the driver alternate between high-and-low-beam at a distance more than 150 meters?

A. Warn each other before passing

B. Driving habit

C. Easy to observe the situation ahead from either side

D. Courtesy

Answer: C

16. As shown in the flash, what should the motor vehicle driver do when encountering this situation?

A. Reserve a safe crosswise distance and cut speed

B. Keep a normal speed

C. Use the emergency brake when approaching

D. Speed up and pass rapidly

Answer: A

17. What should motor vehicle drivers do under such circumstances at night?

A. Turn off the headlamp when approaching

B. Use low-beam

C. Use high-beam

D. Turn off all lamps in advance

Answer: B

18. When a motor vehicle has deviated from the straight moving direction and an accident is unavoidable, the driver should decisively and continuously depress the brake pedal so as to shorten the stopping distance and reduce the impact of vehicle collision.

A. Right

B. Wrong

Answer: A

19. When leaving an expressway, drivers should enter the ramp after slowing down in the deceleration lane.

A. Right

B. Wrong

Answer: A

20. When putting out a fire disaster that gives out corrosive steam or poisonous gas, the firefighters should wear gas masks and other related protective articles and operate from the windward side.

A. Right

B. Wrong

Answer: A

21. When the engine suddenly stalls on the road, what should the driver do?

A. Stop the vehicle and overhaul it immediately

B. Immediately turn on the hazard lamps

C. Move the vehicle to a place where it will not obstruct the traffic flow

D. Set up a breakdown warning sign

Answer: BCD

22. When driving on an expressway, drivers should not frequently change lanes.

A. Right

B. Wrong

Answer: A

23. What should the driver do upon finding that one of the right tires is leaking while driving?

A. Brake swiftly to slow down

B. Brake slowly to slow down

C. Turn to the left side swiftly

D. Apply emergency braking

Answer: B

24. The sign on the right indicates a one-kilometer distance from ETC toll station ahead.

A. Right

B. Wrong

Answer: B

25. When braking failure happens to a fast-moving motor vehicle, what should be done by the driver to brake?

A. Continuously depressing the brake pedal

B. Immediately changing to a low gear to reduce speed and using the handbrake

C. Swiftly depressing the clutch pedal

D. Swiftly pulling up the handbrake

Answer: B