上海考驾照英语

1. What kind of behavior of this driver violates the law?

A. not hold the steering wheel according to regulation

B. angle of the seat is not correct

C. not buckled up

D. the driving posture is incorrect

Answer: C

2. You should speed up to go through the railway crossing in this case.

A. Right

B. Wrong

Answer: B

3. When a vehicle starts to move, the driver should first turn on the low beam light.

A. Right

B. Wrong

Answer: A

4. Which part of the driver can be protected by the safety pillow when there is a rear-end collision?

A. waist

B. chest

C. head

D. neck

Answer: D

5. When driving at night on a road with no or poor lighting, the driver should switch from the low beam light to the high beam light. But the vehicle following in the same direction is not allowed to use the high beam light.

A. Right

B. Wrong

Answer: A

6. Emergency braking on a road covered by ice and snow can easily cause side skidding. The driver should use the engine braking to reduce speed.

A. Right

B. Wrong

Answer: A

7. You may speed up to go through the intersection in this case.Answer：

A. Right

B. Wrong

Answer: B

8. When a vehicle approaches an intersection without crosswalk, the driver should _______ if he finds people are crossing the street.

A. Reduce speed or stop to yield

B. Honk to indicate them to yield

C. Immediately change lane and bypass the pedestrians

D. Pass before the pedestrians

Answer: A

9. Reducing the speed to yield when encountering this situation in the intersection.

A. Right

B. Wrong

Answer: A

10. When encountering a vehicle coming in the opposite direction on a mountain road, the driver should ______ when crossing each other.

A. Not reduce speed

B. Stick to the center of the road

C. Speed up

D. Reduce speed or stop to yield

Answer: D

11. It lights when turning on the front high beam lights.

A. Right

B. Wrong

Answer: B

12. It lights while driving to indicate that ______

A. engine temperature is too high

B. engine cooling system malfunction

C. engine lubrication system malfunction

D. engine temperature is too low

Answer: A

13. Move the switch up and down, the windscreen wipers start working.

A. Right

B. Wrong

Answer: A

14. This sign warns the driver to run slowly with care and beware of the vehicles from horizontal road.

A. Right

B. Wrong

Answer: A

15. What is the max speed when visibility is less than 50m due to foggy, rainy or snowy?

A. 70km/hr

B. 50km/hr

C. 40km/hr

D. 30km/hr

Answer: D

16. You can drive directly into the expressway from this position.

A. Right

B. Wrong

Answer: B

17. Whats the meaning of this sign?

A. payment lane on the expressway

B. check lane on the expressway

C. card getting lane on the expressway

D. ETC lane on the expressway

Answer: D

18. What device does the switch of this symbol control?

A. the windscreen defrosting

B. the rear window wiper

C. the rear window defrosting

D. the windscreen wiper

Answer: D

19. It lights to indicate that ______

A. the side fans work

B. air external circulation

C. the front fan works

D. air internal circulation

Answer: C

20. This set of the hand signals of the traffic police indicates that the vehicles should ___ .

A. turn right

B. reduce speed and pass slowly

C. pull over

D. change lane

Answer: D

21. Whats the meaning of this sign?

A. left-turn lane

B. straight-going lane

C. right-turn lane

D. lanes for going in different directions

Answer: D

22. Whats the meaning of this sign?

A. right-turn lane

B. U turn lane

C. left-turn lane

D. lanes for going in different directions

Answer: C

23. You can overtake from both sides in this case.

A. Right

B. Wrong

Answer: B

24. When a vehicle on the main road approaches a conjunction with a feeder road, the driver should ______ in order to prevent a collision with a vehicle that suddenly enters from the feeder road.

A. Maintain the normal speed

B. Reduce speed in advance, observe and drive with care

C. Honk and swiftly pass

D. Speed up in advance and pass

Answer: B

25. How to use light in this situation at the intersection?

A. turn off high beam lights

B. use hazard lights

C. use the high and low beam lights alternately

D. use high beam lights

Answer: C