贵阳2026考驾驶证英语试题

1. When a vehicle is being overtaken by another vehicle, and there is a vehicle following behind, the driver should _____.

A. continue to speed up and run

B. turn slightly to the right side, keep a safe horizontal distance

C. run by road center

D. speed up to the right side to yield

Answer: B

2. Whats the meaning of this sign?

A. intersection ahead

B. interchange ahead

C. Y-shaped intersection ahead

D. ring intersection ahead

Answer: B

3. When a vehicle stops temporarily in a rainy day, the driver should turn on ______.

A. The head and tail fog lights

B. The hazard lights

C. The high beam light

D. The reverse light

Answer: B

4. When discovering a road congestion ahead, the correct way to deal with this situation is to _______.

A. Continue to weave through

B. Find space and overtake one vehicle after another

C. Honk to indicate the vehicle in front to speed up

D. Stop and wait in line

Answer: D

5. What is the max speed limit on this road?

A. 100 km/hr

B. 90 km/hr

C. 120 km/hr

D. 110 km/hr

Answer: B

6. When a vehicle goes uphill, the driver should observe the road conditions and the length of the slope in advance and shift to the lower gear in a timely manner to ensure the vehicle has sufficient power.

A. Right

B. Wrong

Answer: A

7. How to use lights when overtaking at night?

A. turn off the high beam light

B. turn on high beam lights

C. use fog lights

D. using the high and low beam lights alternately

Answer: D

8. At this position, you may speed up to pass through the section.

A. Right

B. Wrong

Answer: B

9. When a motorized vehicle goes at night through an intersection that has no traffic lights, the driver should not use the high and low beam lights alternately.

A. Right

B. Wrong

Answer: B

10. What is the max speed when passing this curve?

A. 40km/hr

B. 30km/hr

C. 50km/hr

D. 70km/hr

Answer: B

11. Before a vehicle enters an intersection, the driver should reduce speed, observe and make sure it is safe to do so.

A. Right

B. Wrong

Answer: A

12. This sign reminds bump road ahead which may causes bump phenomenon.

A. Right

B. Wrong

Answer: A

13. This sign indicates construction section ahead and bypassing from left or right side.

A. Right

B. Wrong

Answer: B

14. A driver should drive the vehicles in accordance with the qualification listed on the driving license.

A. Right

B. Wrong

Answer: A

15. Max speed when pass the narrow road or bridge is _______

A. 50km/hr

B. 40km/hr

C. 30km/hr

D. 60km/hr

Answer: C

16. It displays the current engine speed is 6000 rev / min.

A. Right

B. Wrong

Answer: B

17. What pedal is it?

A. clutch pedal

B. accelerator pedal

C. brake pedal

D. handbrake

Answer: C

18. Driving a small passenger vehicle at 100km/hr on the expressway, the minimum distance from the vehicle in front is _____ .

A. not less than 20 meters

B. not less than 10 meters

C. not less than 50 meters

D. not less than 30 meters

Answer: C

19. Whats the meaning of this sign?

A. payment lane on the expressway

B. check lane on the expressway

C. card getting lane on the expressway

D. ETC lane on the expressway

Answer: D

20. How to use lights when entering the speed-reducing lane?

A. turn on the hazard lights

B. turn on the head light

C. turn on the left-turn signal

D. turn on the right-turn signal

Answer: D

21. A rear tire blowout can sway the tail of the vehicle. The driver should firmly hold the steering wheel with both hands to ensure the vehicle go straight, reduce speed and then stop.

A. Right

B. Wrong

Answer: A

22. A motorized vehicle is not allowed to stop in the section 50 meters to the bridge, steep slope or tunnel.

A. Right

B. Wrong

Answer: A

23. Traffic Police can detain the vehicle which is suspected of using other vehicles license plate and vehicle license.

A. Right

B. Wrong

Answer: A

24. The driving license of a motorized vehicle driver will be detained after his penalty scores reach 12 points in a scoring circle.

A. Right

B. Wrong

Answer: A

25. What mark is the inclined yellow and black lines?

A. entity mark

B. protrusions mark

C. three-dimensional mark

D. deceleration mark

Answer: C